New SIGA-HDT

[gmcorreia]

Hello Everyone !

Recently i'm acquired a SIGA-HDT and along with it, came a pendrive with a software. I installed the Kidde Diagnostic Tool software, but when connecting the SIGA-HDT via USB port, it does not communicate with the software. Does anyone know if there is a version of this software from Edwards System Tech ?

Kidde Diagnostic Tool
Software Version: 1.3
Build: 3798

Note: My SIGA-HDT works fine to test EST-3 loops, but i'm appreciate if can make reports trough this software.

Regards,

[stagerlee]

There is two ways to get your reports one is just stick a flash drive it the usb port on the box there will be a flopy disk icon come up in the top right corner of the touch screen touch it and it will open a save window and it will save everything you have run. or the problem i had with the software was i was using a micro charging cable but you have to use a micro usb sync cable you will hear a tone like you plued a flash drive in and your software says bootloader then hdt connected.

[gmcorreia]

Hello Everyone,

My EST support send me a Signature Diagnostic Tool Software correct for EST.

Thanks !

[Nirujan]

Hello Everyone,

My EST support send me a Signature Diagnostic Tool Software correct for EST.

Thanks !

Hi, i need small details about this tool, could you check and tell me that in SIGA-HDT after connecting loop cable if we short positive and negative wire of the loop cable will it isolate and protect the SIGA-HDT without burn the fuse, like what 3-SDDC1 loop card doing, because i heard one of my friend said that if short in the loop cable which is connected with SIGA-HDT that will damage the fuse, because its dont have short circuit loop isolator in built, to conform it i need your help friend , please check and tell me, thanks .

[RexDy]

Hi guys,

My boss just gave me a new Siga HDT , first time using it. At first after initializing it reads all the devices, but after a while it didn't read any devices at all.

Can someone help me on this. Thank you