TheAlarmTech.com

Hello all,

I recently rebuilt the database on a 2 panel. After downloading I keep getting the same faults. Internal Memory Fault, Mapping Error, Autoconfigure fault.
I can not get them to go away. My map is clean. I pulled it, accepted all, relabeled, wrote new rules, everything looks good. I can't figure out why I keep getting these faults.

any help would be appreciated.

Check project parameters to ensure the correct mcm version is chosen.

Thanks. Going back to site tomorrow. Will look at the parameters and see if I fudged up the mcm version.

Most likely you have a bad 2-MCM (or 2-lcx). Sometimes a bad device will cause an internal error. If you remove the data loop wire and download a test program with nothing in it and still see the error, you know for sure.