Page 1 of 1
Re: working on siemens panel
Posted: Tue Mar 12, 2019 6:45 am
by Leo
when you say stead the same, you mean trouble did not move, still on ds2
replace the nac panel
stop thinking
Re: working on siemens panel
Posted: Tue Mar 12, 2019 6:52 am
by Birdem
correct stayed the same and the voltage dropped. Yeah I ordered a new panel already. I was just wondering if anyone came across this type of issue before. Thanks for the response leo
Re: working on siemens panel
Posted: Tue Mar 12, 2019 6:37 pm
by isatronix
ect: Re: Notifier Program - VeriFire Tools 5.7 - NO License needePostPosted: Sat Feb 09, 2019 6:21 pm
Joined: Fri May 04, 2018 10:00 am
Posts: 36
Software for programming fire panels free KeyUSB dont needed license
1. VeriFireTools V9.1 VerifireTools V10.0
MultiBrand for: Notifier, Honeywell, ADT, JHONSON CONTROL , AUTOPULSE (ANSUL), CHEMETRON, MINIMAX ODM, NOTIFER AUSTRALIA, NOTIFIER NUEVA ZELANDA, HONEYWELL AUSTRALIA, HONEYWELL NUEVA ZELANDA,
2. Simplex Programmer para 401ES 4100ES
3. 3-SDU Edwards Programmer para EST3 EST3X
4. MGC configurator Mircom para Flexnet
5. Camworks para GameWell E3 S3
6. Zeus for Xls pathfinder Siemmens
Write for more info to:
freddymarv@hotmail.com
Re: working on siemens panel
Posted: Fri Mar 15, 2019 1:07 pm
by isatronix
Birdem wrote:correct stayed the same and the voltage dropped. Yeah I ordered a new panel already. I was just wondering if anyone came across this type of issue before. Thanks for the response leo
Zeus v4.0 5.0 6 7 8 10 11 12 and ver14 for XLS Panel PMI1 PMI2 ... PMI10
freddymarv@hotmail.com
working on siemens panel
Posted: Mon Mar 11, 2019 3:35 pm
by Birdem
Im working on a siemens panel to be more specific a pad 3 distributed power module. I have a trouble on nac 2 (ds2 led lit) I have no open, short or ground on nac 2. It is giving me an output of 13vdc instead of 24vdc. I even swapped nac 1 and nac 2 and my trouble and output voltage stays the same at 13vdc. Anybody can help? thanks.