FCI S3 Programming
Posted: Mon Jan 15, 2018 11:14 pm
Has anyone been able to program an FCI S3 panel with Hyper Terminal?
TheAlarmTech.com
https://est3www.thealarmtech.com/forum/
FCI S3 Programming
https://est3www.thealarmtech.com/forum/viewtopic.php?f=54&t=1466
Page 1 of 1
Re: FCI S3 Programming
Posted: Sun Jan 20, 2019 7:37 pm
You are unable to program an S3 with any software other than CAMWorks. The S3 has a complex series of strings that prevent any access to the software programming other than by an active CAMWorks programming with matching HID
Re: FCI S3 Programming
Posted: Thu Jan 31, 2019 12:14 pm
...... info inbox or writing to email: freddymarv@hotmail.com
Re: FCI S3 Programming
Posted: Thu Dec 10, 2020 12:58 pm
Software CamWorks V3.5 for E3 S3 series Gamewell-FCI By HoneyWell freeKey... info inbox mbaltazar_s@hotmail.com