Page 1 of 2
EST3 to BMS Communications Bridge FSB-PC
Posted: Sun Jan 27, 2013 10:06 am
by hijazih
Hi all,
Has anyone used FSB-PC before?? please advise how to import the addresses to the FSP-PC configuration software.
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Mon Jan 28, 2013 5:11 am
by junjun
give me the details or the points to be monitored by BMS i will configure it for you..
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Mon Jan 28, 2013 7:30 am
by hijazih
I still didnt run the fire alarm panel. I'm still in the installation phase. If u can tell me how to deal with such device it would be good.
what details you want, i can get some data from an existing project so that to get familiar with this device.
thank you
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Mon Jan 28, 2013 9:49 am
by junjun
You can give me which device logical address of fire alarm to be monitored and what kind of communication to be use between fsb-pc and bms.
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Mon Jan 28, 2013 9:55 am
by junjun
Its either one of this protocols:
Bacnet-ethernet
Bacnet-ip
Modbus
Lonworx
Etc...
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Mon Jan 28, 2013 12:43 pm
by hijazih
Can i use 2 protocols simultaneously, i mean i want to interface with two systems using 1 FSB-PC, but each system using separate protocol.
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Tue Jan 29, 2013 12:43 am
by junjun
No, cause every protocol have different configuration table.
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Wed Jan 30, 2013 7:45 am
by hijazih
i've attached a sample of the logical addresses
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Thu Jan 31, 2013 2:15 am
by hijazih
Do any protocol sends ASCII data ???
Re: EST3 to BMS Communications Bridge FSB-PC
Posted: Thu Jan 31, 2013 5:15 am
by junjun
here's are one sample for configuring Bacnet IP protocol.