Page 1 of 1
Programming a Pseudo Point
Posted: Mon Nov 08, 2010 12:39 pm
by tAP135
Just wondering how I can program a Pseudo Point. Looked through the SDU help and nothing.
I want to create a logical point the I can turn on and use if I want.
mostly I want to put an input into limbo.
Re: Programming a Pseudo Point
Posted: Mon Nov 08, 2010 1:25 pm
by Leo
Look up logical outputs in the SDU help
from SDU help - Overview of logical outputs
Logical outputs are abstract entities that mimic the operation of nonsupervised relays. They provide a convenient method of developing complex system interactions. Logical outputs can be activated and restored from front panel menus or through rules programming. Activating a logical output produces a relay confirmation event (RelayConfirmation or RLYCFG) that can be incorporated in rules and used to drive further operations.
if it this does not help let us know
Re: Programming a Pseudo Point
Posted: Tue Nov 09, 2010 12:35 am
by BROS
Pseudo points Honeywell FS 90 CAE programming - takes me back !
Re: Programming a Pseudo Point
Posted: Tue Nov 16, 2010 10:22 am
by tAP135
thanks Leo - that is exactly wha tI was looking for.
I am used to Pseudo working with the Seimens panels.