Page 1 of 1
EST3 CPU rebooting at the time of SDU communication
Posted: Thu Nov 28, 2019 4:04 am
by razibul80
Dear ALL,
I have been getting trouble with my EST3 CPU3 during communication with the 3-SDU V5.20. The controller is rebooting when I connect my laptop to that and open the project. The project version in bothe laptop and controller are same. I am using floating license (Multikey32) in my laptop instead of physical dongol. Please anyone can help me why the CPU goes rebooting when it is connected to the 3-SDU laptop.
Your co-operation is highly expected.
Thanks in advance.
Re: EST3 CPU rebooting at the time of SDU communication
Posted: Thu Nov 28, 2019 7:53 pm
by Hiep Nguyen
razibul80 wrote:Dear ALL,
I have been getting trouble with my EST3 CPU3 during communication with the 3-SDU V5.20. The controller is rebooting when I connect my laptop to that and open the project. The project version in bothe laptop and controller are same. I am using floating license (Multikey32) in my laptop instead of physical dongol. Please anyone can help me why the CPU goes rebooting when it is connected to the 3-SDU laptop.
Your co-operation is highly expected.
Thanks in advance.
Dear Sir,
Can you sent to me your SDU file and license ( Multikey32) with pincode to my email:
ngochiep.me@gmail.com
I will check it and guide me fix this problem.
Thanks,
Henry.
Re: EST3 CPU rebooting at the time of SDU communication
Posted: Wed Jul 01, 2020 12:22 pm
by fireprotectionsun
I have seen this happen i have a few of different cables it has happened a few times with two of them and not the other. Noticed it when i have the cable plugged in panel and then pug in the com port (usb)
Re: EST3 CPU rebooting at the time of SDU communication
Posted: Fri Jul 03, 2020 11:58 pm
by Nirujan
razibul80 wrote:Dear ALL,
I have been getting trouble with my EST3 CPU3 during communication with the 3-SDU V5.20. The controller is rebooting when I connect my laptop to that and open the project. The project version in bothe laptop and controller are same. I am using floating license (Multikey32) in my laptop instead of physical dongol. Please anyone can help me why the CPU goes rebooting when it is connected to the 3-SDU laptop.
Your co-operation is highly expected.
Thanks in advance.