TheAlarmTech.com

Hello I am getting a timer test with trouble but the fire alarm panel is normal. However when i view status Troubles i can see....
First Trouble Act
P:00 C:00 D:004
First Trouble Response
P:00 C:00 D:0026
CMS First Trouble Response
P:01 C:03 D:686
Unprogrammed Device Data Card 2

I do not show any unprogrammed devices when i compile rules or upload my maps.
Any clues as to what i can look for?

Thanks again You guys have always been great help.
Joe

the timer test is working right you do have a trouble on the system
the trouble is not being routed to that display which you can look into
did you upload loop2
I would bet if you look hard you will find that there is a problem with this loop
when you change a device I sometime get an unprogrammed device