Page 1 of 1
Re: Using SIGA_PRO To Changing Detector
Posted: Sat Jun 13, 2015 9:16 am
by Leo
I do not think so.
a unprogrammed device is not in the program that was loaded to the panel.
so even if you could give it a address it would still be unprogrammed.
Re: Using SIGA_PRO To Changing Detector
Posted: Sat Jul 04, 2015 2:27 am
by hijazih
Hi Zeroo,
if the loop mapping is complete, remove the faulty detector, wait for aprox. 3 min. then install the new detector, wait for few minutes then the unprogrammed trouble will be restored.
if you have more than 1 detector, do this whole process for the first then try the second and so on....
Please give me your feedback
Using SIGA_PRO To Changing Detector
Posted: Thu Jun 11, 2015 8:16 am
by ZEROO
Hi Engineers,
I Have Small Problem in One Project ,We Need To Change Some Faulty Detectors
MY Question :We Can changing This Detectors By Adjusted The Address By SIGA_PRO Without to give Us UnProgrammed Device Trouble ,
If We Can What The Standard Procedure ?