Page 1 of 1
Re: Status Panel for EST3
Posted: Tue Apr 14, 2015 3:35 pm
by Leo
Are you looking for LEDs
Re: Status Panel for EST3
Posted: Mon Apr 27, 2015 9:28 pm
by khorasani
Hi Leo,
not only leds,I want a status panel that could change the system to auto/manual/inhibit by switch ,like status panels that Kentec company produce for its extinguishing system.
thanks again.
Re: Status Panel for EST3
Posted: Wed Jun 03, 2015 2:44 am
by briac
Hi,
for the siga REL you can use disconect switch as it is presented on the siga REL for off mode
the you can use rules to disable the auto on the AND group for manual mode.
eneble the AND group for automatic mode.
I know it is very global answer but come back to me for more precision.
hope to help you.
Status Panel for EST3
Posted: Sun Apr 12, 2015 1:09 pm
by khorasani
Hi everybody,
I am looking for a status panel that provide me the states of panel(enable/disable, Released conditions,fault and fire in system.and disabling the system by a switch).
My fire alarm panel is EST3 ,also I have extinguishing system(FM200) that activate by siga-rel module.
Any Suggestions?
many thanks:)