Kantech KT1 L2 output
Posted: Tue Oct 11, 2022 3:48 pm
I have a question. I have a KT1, and have noticed that while L1 is "locked" (LED indicator is off), L2 is LED is lit. When I unlock the door strike with a card or via entrapass, they switch. L1 Lights that the door is unlocked, and L2 LED goes out (until the door relocks, and they swap again.)
Door strike on L1, nothing wired to L2.
I can't seem to figure out where to change it so that L2 stays off?
Door strike on L1, nothing wired to L2.
I can't seem to figure out where to change it so that L2 stays off?