TheAlarmTech.com

QuickStart Panel
Dialer String Setup for miscellaneous Troubles

When the Quickstart panel has a ground fault, Battery trouble, telco fail or AC loss it will only send a panel trouble to the CS unless you add these dialer strings

Adding dialer strings for Panel NAC Circuit,telco,AC fail and battery troubles
Update Device address
1.1.270 NAC output off of panel power supply
1.1.271 NAC output off of panel power supply
1.14.1 Telco Trouble Primary
1.14.2 Telco Trouble Sec.
1.15.2 Battery Fault
1.15.7 AC power fail
1.15.9 Check system wiring AKA: Ground Fault

Default CID Codes:
351 Telco 1 fault
352 Telco 2 fault
301 AC Loss
302 Low System Battery
310 Ground Fault

Navigate to:
Configure->Correlation->Device Tab->(check) Show Pseudo Points
select address, then Response Type (Trouble), click Dialer String
String

1.1.270 NAC output off of panel power supply
Active 130001270, Restore 330001270

1.1.271 NAC output off of panel power supply
Active 130001271, Restore 330001271

1.14.1 Telco Trouble Primary
Active 135100000, Restore 335100000

1.14.2 Telco Trouble Sec
Active 135200000, Restore 335200000

1.15.2 Battery Fault
Active 130200000, Restore 330200000

1.15.7 AC power fail
Active 130100000, Restore 330100000

1.15.9 Check system wiring AKA: Ground Fault
Active 131000000, Restore 331000000