TheAlarmTech.com

hI ALL,

I have a panel , which is Mirtone make Quickstart . I have used EST QS-CU software but it does not communicate.

So , I have replaced CPU ,now its communicating with CPU . But Smoke detectors also is EST-Mirtone Type. So I get trouble for all detectors . Detectors are working fine on smoke test, Hooter are also activated . But it shows traouble afor all the detectors.

Some one Pls Help to sort out this problem.

regards

hi, you need to put back the older cpu an used the mirtone Quickstart software MIRQS-CU.

regards...

Older Mirtone CPU is fail aow i have to use this QS4 CPU only.

Currently i am getting alarms if testing any detector . But i don get any troubles for open/ short in loop.

mirtone quickstart = Mirtone devices

est quickstart = Est devices

had a Mirtone cpu Panel fail 8 months ago, tried to swap with EST QS CPU, ended up replacing all smoke detectors due to non-compatibility

per EST tech support the smokes are NOT compatible, but the modules are compatible .