Re: SIGA-AA50 Audio Amplifiers
Posted: Sat Jan 25, 2020 1:33 pm
There is really not much to do other than activate the address.
From installation sheet:
"Activating the primary (first) address selects the signal on channel 1. Activating both addresses selects the signal on channel 2."
You should however have an audio source to feed the amplifier like 3-ASU(FT), 3-ZA20 set to 25v.
From installation sheet:
"Activating the primary (first) address selects the signal on channel 1. Activating both addresses selects the signal on channel 2."
Code: Select all
ON -LOW AUD 'Your_Label_Here',