TheAlarmTech.com

Turn the amp on without a priority then disable the evac message to amps With a -HIGH

- Turn the evac message off high
[SW1 EVAC MESSAGE OFF] SW 'SW1' : OFF AMPOFF 'ZA20_AMP' TO 'Ch_Evac_01_08';
[SW1 EVAC MESSAGE OFF] SW 'SW1' : OFF -HIGH AMPOFF 'ZA20_AMP' TO 'Ch_Evac_01_08';

ALSO Check box: Re-evaluate SET Priorities on Restore
Configure->project parameters->operations->Re-evaluate SET Priorities on Restore


Note: by default SWITCHES turn on/off/disable with a -HIGH

[SW 1-1-2 SPKS OFF] SW 'PANEL1_SW1' : OFF '*SPEAKER*';
IS THE SAME AS
[SW 1-1-2 SPKS OFF] SW 'PANEL1_SW1' : OFF -HIGH '*SPEAKER*';

hi

is it possible to turn off an alarm which is connected to a CC1 via a switch(SW)?

and also is it possible to eliminate the delay (DLYA) for an alarm which is connected to a CC1 via a switch(SW)?