Does anyone have a template that gives you the sizing when you plot from auotcad to open in Fireworks 8.2 or 8.3.
It would be appreciated
EST Fireworks Drawing Sizing
-
fireprotectionsun
- Posts: 3
- Joined: Sat Jun 27, 2020 7:40 am
Jump to
- General Comments/How To Register
- ----- F i r e -----
- ↳ MANUALS
- ↳ NICET, NPFA72/70, State License
- ↳ NPFA72/70
- ↳ UTC - EST
- ↳ License,Dongle & Software Certificate
- ↳ EST3
- ↳ EST4
- ↳ EST3 Rules
- ↳ I/O panels
- ↳ QuickStart
- ↳ FireWorks
- ↳ EST2
- ↳ Misc/Devices
- ↳ IRC3
- ↳ Notifier
- ↳ Fire Panels - 640,2020,3030
- ↳ ONYXWorks
- ↳ FireLite
- ↳ SilentKnight
- ↳ Ademco - V32FB
- ↳ Fire Alarm Inspection
- ↳ Other FACP
- ↳ Duct Detectors
- ---- C a r d A c c e s s ----
- ↳ GE - Secure Perfect, Micro5
- ↳ Facility Commander/Secure Perfect
- ↳ Hardware
- ↳ Honeywell - Winpak
- ↳ honeywellaccess.com
- ↳ HoneyWell - ProWatch
- ↳ HoneyWellIntegrated.com
- ↳ Kantech
- ↳ Readers
- ↳ hidglobal.com
- ↳ HoneyWellintegrated.com - readers
- ↳ honeywellaccess.com - readers
- ↳ Card Access Systems
- ↳ Credentials
- ---- Other Systems ----
- ↳ Other Systems, DVR, Camera,
- ↳ communications protocol - RS232 RS485 RS422 TCP/IP Networking
- Heliostat
- ↳ Heliostat
- ↳ heliostat.us