Can anyone tell me if you can customize the view of the map in sdu ver 5.2.
It shows too much information for each device on the map...
Search found 3 matches
- Sun Dec 14, 2014 6:37 pm
- Forum: EST3
- Topic: EST-3 5.2 Mapping
- Replies: 1
- Views: 2780
- Sat Oct 11, 2014 4:09 pm
- Forum: EST3 Rules
- Topic: EST3 Rules-Disabling outputs via the DRILL SWITCH
- Replies: 2
- Views: 7527
Re: EST3 Rules-Disabling outputs via the DRILL SWITCH
Sorry I forgot a very important step. 1. install a cr-relay common/ no to a ct-1 module with resistor accross relay common / n/o. 2. Program the CT-1 as a supv. and make the message : ALL OUTPUTS DISABLED FOR SERVICE 3. When the drill button is pressed it activates the CR-relay called 'OUTPUT_DISABL...
- Sat Oct 11, 2014 4:02 pm
- Forum: EST3 Rules
- Topic: EST3 Rules-Disabling outputs via the DRILL SWITCH
- Replies: 2
- Views: 7527
Re: EST3 Rules-Disabling outputs via the DRILL SWITCH
Hi - I use the drill button to disable all outputs because its password protected. 1st change the switch config under project, parameters, key function. choose switch 4 and add in"system function 4" then access level 4 - for all 4's as the password. 2. Add this rule:[DISABLE VIA DRILL BUTT...