TheAlarmTech.com

set you jumper setting to 1v or 25v/70v located on the left side facing the aa50 on the input terminal. your wire connection and jumper setting must be on the same setting or terminal.

after you commit expected, just compile rules,convert and download that specific loop. after download let it map it again then upload again, then you will see that it is matched. you will get this properly if your configuration is mapping enabled. but if your mapping is disabled and your ps is sound...

What is the wiring type? Class A or class B? If class A, it's 3A and 2ckt per aps6a, if class b, it's 1.5A per ckt and its 4ckts per aps6a.

Check thoroughly each of your device installation or your base. One of your device is faulty. First check your isolator bases, the connection of in and out negative. Then your sounder bases if you have in the loop, if not then procced to the heat detectors, maybe one of it is in internal trbl. Make ...

try this: it might work. remove battery power from cpu. connect your j5 jack to the cpu, prepare your sdu up to the point before hitting the start button of cpu database download, single step, make sure you've done your compiling and conversions. upon powering up your panel with ac supply, hit the s...

hehehe try this...... this is more clever thing to do. go to: configure > cabinet > select which cabinet that have LCD that you dont want to appear the events, then: options tab(between ports and microCode) > look for display enabled (upper left part of the window tab) uncheck what type of events yo...

yes you can do what kind of address you want as per your as built address. But it is limited to... for loops 1,3,5,7,9 and so forth detectors address 1-125, and modules 126-250. for loops 2,4,6,8,10 and so forth detectors address 251-375 and modules 375-500. this is what you will do..say you are in ...

thanks Le, I'll try to look into this. How about my previous post regarding the HASP key number, can we take that information from the exiting panel of someone else's system?

yes Le, there is RS232 card in it. So can I use the same cable that I'm using in the Quick Start? But first I have to configure the port, right? printer, 9600 baud, which port? Port one or port two doesn't matter? and open the sdu software? Le, I don't get you regarding open hyperterminal and run an...

and Le, sorry I forgot one thing, regarding to your last paragraph of more fun taking over someone else's system. Is there any ways we can extract the device location? Just like in the Quick Start, when you retrieve the database in the panel, you will get everything including the message location of...