TheAlarmTech.com

I suggest to change the baudrate to 19200 , then download the CPU . Make sure you have the correct COMM port in the device manager in your PC ( if you are using a USB to serial cable which i prefer ) Next step , open system builder update your comm port and baud rate , choose your node , save and ex...

I am using fireworks version 1.71 and an old parallel port dongle on a windows 7 I used to silence the panel from fireworks after acknowledging all the events , but its not working anymore now. I would like to silence the panel after acknowledging all the events Although the communication is success...

sometimes when i read a SIGA loop the it starts to map and falls down a lot of times, and in the end it settles as a map fault.

I tried to swap the IN with The OUT loop cables but the problem persists.

What can i do i cant fix the problem.

Thanks

dear Jimm I ordered new patch cords single mode glass type fiber cables and still no communication. I wont have time to order the 3-FIBMB2 new card because i have very limited time to hand over the project. I checked every single point in the installation (adaptor card , ribbon cable , power 24VDC ....

thanks jimm my company in Egypt HF-Fire ordered the single mode fiber cables and awaiting their confirmation

Thanks a lot for your support your information was very valuable to me

dear jimm

The 3-fiba card i use is a multi mode card and the wire between the two panels are single mode

is there a converter to convert from multi mode to single mode ?

thanx a lot guyz for you immediate response

youv been very helpful

Dear all, Im stuck in a project that has 8 panels with 3 of them are connected to each other by a fiber cable and the other 5 are connected to each other by copper cables I connected the panels with the copper cables but i can't seem to connect the fiber cables to the panels even though i installed ...

I have a problem with some loops when i read all devices and says mapping in progress Example : there are 130 device and it only maps to 75 and falls back again to 0 and so on untill it says map fault i tried mapping errors but everytime it gives me a diferent serial number of a device and nothing s...

I have a linear heat cable twisted along data cables in an airport and i dont know how to control this linear heat cable on the fire alarm panel

Can anyone help on how to install , test

Thanks